Marine Decals

• 4" x 4" 
• VINYL

Directions for application:

1. Clean surface thoroughly (temperature should be above 50° f)

2.  Turn decal upside-down (imprint side down) and place on a flat surface.

3.  Separate the clear liner from the foggy “pre-mask” material making sure the decal stays attached to  the “pre-mask”. If needed, use your fingernail to hold the edge of the decal to the “pre-mask” when removing clear liner.

4.  Carefully place decal in desired position.  With fingers (or a credit card) firmly rub decal from the center out in all directions.

5.  Remove “pre-mask” at a 180 degree angle (rub down decal as necessary).

6.  Puncture bubbles with sharp needle; then lightly press area to remove trapped air.